4.8/5
4 locations in the Netherlands085 - 1301 965EN

Attention points hinged door

  • For a hinged door, the ceiling should be solidly screwable, this can be concrete, stone or wood.
  • With plasterboard, we recommend applying at least 2 times 18 mm plywood above the plasterboard, otherwise we will not be able to fit the doors.
  • For steel beams, we recommend that they be clad with 2 times 18 mm plywood.
  • In a suspended ceiling, a strip grid is to be installed. 4 cm of wood should be fitted behind this strip grid.
  • In the ceiling we must be able to drill at least 4 cm, no pipes should run within this distance.
  • The floor must also be solid. For a double-hinged door, we need to drill 10 mm in the floor. This is for the purpose of the edge slide incorporated in the passive door. With a single-hinged door, it makes no further difference. Underfloor heating is normally not a problem because we only need to drill 10 mm deep. Here, the living floor (tile or glued floor) also counts.
  • Are you still going to have the underfloor heating installed and your wish is a double-hinged door? Then feel free to contact us to take this into account right away.
  • Walls and ceilings should be finished as straight and level as possible. This way, you will have the best end result and minimal gaps will be created.
  • The walls and ceilings should be finished as if there will be no door.
  • Also make sure there are no smoke detectors, lamps and/or air intake points in the turning directions. Further also at the door location there should be no switches or sockets.
  • With skirting boards we have to cut a piece out of the skirting boards, to avoid this you cannot use skirting boards or adhesive skirting boards (flat on the floor). This can also be read further under the heading Assembly. The cut edges must be finished by a painter, this is not something we do. If skirting boards are made of stone, we are not responsible for them cracking due to poor gluing, and the same applies to floor tiles.
  • All panels can have a size/straightness tolerance of 4 mm.
  • With the magnetic closure, it is always possible for the door to spring open due to air pressure differences.
Change language
Dutch
English
Curious about the possibilities?Request a quoteShowroom visits